YOUR CUTTING SHEET
A place for every piece.
Inputs changed. Generate again before cutting. The sheet below still shows your previous measurements.
Enter your lengths, then generate a plan.
Start with the length of one full strip, allow for the cut gap, then list the pieces you need.
You’ll get numbered strips with an ordered cutting guide and visible leftovers.
100 mm stock · 2 mm gap · two 45 mm pieces
Longest pieces first; each goes into the first strip with room.
Not guaranteed to use the fewest strips.
- Strips required
- 0
- Pieces placed
- 0
- Pieces unplaced
- 0
Unplaceable pieces
Piece
Cut gap
Leftover
No pieces fit this stock. Use longer stock or change your requested lengths, then generate again.
Read each strip from left to right. Diagonal marks show leftover material. The ordered lengths below each diagram label even the smallest pieces.
Generate again to download a cut list for your changed measurements.